Hc Sr04 - Troubleshooting
This page contains some tips in case you are having problems using this product.
Check wiring
Ensure that your Qwiic cable is properly connected and in good condition. Try using the same cable with another easyC-compatible device to verify that it works. If the issue persists, swap it out for a different cable to rule out any possible damage or defects.
Check I2C pins
If you are connecting the sensor using standard I2C pins on your microcontroller, double-check that you are using the correct ones. Different microcontrollers have designated I2C pins that may not always be labeled the same way. Refer to your microcontroller's documentation to confirm the correct pin assignments.
Scan for I2C devices
Run an I2C scanner sketch on your microcontroller to check if the sensor is detected. If the scanner does not find any devices, there might be a wiring issue, incorrect pull-up resistors, or a problem with the microcontroller’s I2C bus.
Check for conflicting devices
If you have multiple I2C devices connected to the same bus, ensure that none of them have conflicting addresses. You can change the I2C address of the board with the address switches.
Try reinitializing
If the sensor fails to initialize on the first attempt, try calling hc_ultrasonic.begin() again in your code or resetting your microcontroller. Some initialization issues may be resolved by a simple reboot.
Adjust measurement timing
If your code is taking multiple readings too quickly, the sensor may not have enough time to process the previous pulse before sending a new one. Increase the delay between measurements to ensure more accurate readings.